Realization of superposition and entanglement of coherent and squeezed states in circuit quantum electrodynamics

We propose a new scheme for generating the superposition and entanglement of the coherent states and squeezed states by considering N superconducting charge qubits (or artificial two-level atoms) interacting with photons in a high finesse cavity on a chip, assisted by a strong driving field. By virtue of the parameters of this system, we can generate novel quantum states, for example, multiparty entangled states and Schro¨dinger cat states among the superconducting qubits, coherent states and squeezed state...     

不同磁路下微型ECR中和器电子引出的模拟研究

电子回旋共振(ECR)中和器是微型ECR离子推力器的重要组成部分,其引出的电子用于中和ECR离子源的离子束流,避免了航天器表面电荷堆积,并且电子引出性能对推力器的整体性能起着重要作用.为了分析影响微型ECR中和器电子引出的因素,本文建立了二维轴对称PIC/MCC计算模型,通过数值模拟研究不同磁路结构对中和器的电子引出,及不同腔体长度对壁面电流损失的影响.计算结果表明, ECR区位置和引出孔附近磁场构型对中和器的电子引出性能至关重要.当ECR区位于天线上游,电子在迁移扩散中易损失,并且电子跨过引出孔前电势阱所需的能量更高.如果更多磁力线平行通过引出孔,中和器引出相同电子电流所需电压较小.当ECR区被天线切割或位于下游时,电子更易沿磁力线迁移到引出孔附近,从而降低了收集板电压.研究了同一磁路结构下不同腔体长度对电子引出的影响,发现增加腔体长度,使得更多平行轴线的磁力线通过引出孔从而避免电子损失在引出板表面,增加了引出电子电流.研究结果有助于设计合理的中和器磁路和腔体尺寸.     

Contact between two plastically deformable crystals: a discrete dislocation dynamics study

It is customary to simplify the analysis of contact between two elastically deformable bodies by treating an equivalent problem where only one body is deformable and the other is rigid. This is possible provided that the gap geometry and the effective elastic modulus of the bodies in the simplified problem are the same as in the original problem. However, the question arises on whether – and to which extent – the simplification is still valid even when (size-dependent) plasticity occurs. Studies using discrete dislocation plasticity have also, so far, addressed simple contact problems where only one body can deform plastically. Here, we extend the analysis to two bodies in contact that can both deform by dislocation plasticity and investigate under which conditions the response agrees with that of an equivalent simplified problem. The bodies in contact are metal single crystals with sinusoidal and flat surface. It is found that the response of two plastically deformable bodies in contact can be simplified to an equivalent problem where one body is rigid and the other can deform plastically. Also, a plasticity size effect is observed, but the effect fades when the platen becomes more plastically deformable.     

Intramolecular nucleophilic attack at silicon in o-silylbenzyl alcohols. Generation of allyl and benzyl anion equivalents

Substituted silyl ethers of o-bromobenzyl alcohols and the derived o-silylbenzyl alcohols were used to transfer allyl and benzyl groups from silicon to the electrophiles benzaldehyde and benzophenone in excellent yields. γ-Oxidosilane intermediates (and possibly hypercoordinated silicon intermediates) are postulated.     

无气味代硫醇试剂的合成与应用研究进展

综述了无气味硫醇和硫化试剂的合成及其作为代硫醇试剂在有机合成中应用的研究进展.     

Treatment of TiO2 with COOH‐Functionalized Germanium Nanoparticles to Enhance the Photocurrent of Dye‐Sensitized Solar Cells

A dye‐sensitized solar cell (DSSC) containing a TiO₂ film treated with COOH‐functionalized germanium nanoparticles (Ge COOH Nps) exhibited a higher short‐circuit photocurrent density (J_sc; 15.4 mA cm⁻²) compared to the corresponding untreated DSSC (13.4 mA cm⁻²) using N719 and a 12 μm thick TiO₂ film at 100 mW cm⁻². The amount of N719 attached to the treated TiO₂ film was 21 % greater than that attached to the untreated TiO₂ film. Enhancement of the J_sc value by 15 % was attributed mostly to an intramolecular charge transfer from N719 attached to the Ge COOH Nps to the TiO₂ conduction band through the Ge COOH Nps.     

超高效液相色谱-串联质谱法测定印刷电路板中全氟辛烷磺酸盐

经剪碎和粉碎的印刷电路板样品用甲酸-甲醇(0.1+99.9)溶液超声提取,所得提取液于45℃旋转蒸发至1mL,加水5mL,用稀甲酸或稀氨水调节溶液的pH值为4～5。将溶液通过Oasis WAX固相萃取小柱净化,用甲酸(2+98)溶液和甲醇先后清洗小柱后,用氨水-甲醇(2+98)混合溶液洗脱,将全部洗脱液氮吹蒸发至近干,用流动相溶液定容为1mL供测定。所用色谱柱为Acquity UPLC BEH C18柱,柱温30℃,进样量为5μL。由5mmol.L-1乙酸铵溶液及乙腈(60+40)混合溶液作为流动相,在0.3mL.min-1流量条件下进行洗脱。质谱测定中采用ESI负电离方式,多反应监测扫描模式。测得全氟辛烷磺酸盐质量分数在1.0～1 000μg.kg-1范围内与峰面积值呈线性关系,测定下限(10S/N)为1.0μg.kg-1。用标准加入法测得回收率在89.0%～99.3%之间。     

循环流化床富氧气化实验研究

在循环流化床富氧气化实验台上,通过调节水蒸气流量使气化温度基本稳定在910℃,研究了不同氧气浓度及气化当量比对煤气组分、产气率、冷煤气效率及碳转化率的影响。结果表明,氧气浓度从25%增加至40%时,N2体积分数从48.82%降低至33.83%,H2从21.47%不断增加至27.59%,CH4基本不变;受水蒸气流量影响,氧气浓度高于35%时,CO体积分数降低,CO2体积分数增加;氧气浓度40%时的煤气热值为空气气化煤气热值的1.84倍,产气率随氧气浓度增加从2.35 m3/kg降至2.13 m3/kg,冷煤气效率和碳转化率不断增大;当气化当量比从0.20增加至0.29时,N2体积分数先降低后升高,H2体积分数从24.01%增加到25.46%后基本保持不变,CO和CH4持续减小,CO2不断增加,产气率由1.94 m3/kg升高到2.29 m3/kg;受水蒸气和气化当量比综合影响,冷煤气效率先增大后减小,碳转化率持续增加。     

Experimental validation of an effective carbon number-based approach for the gas chromatography–mass spectrometry quantification of ‘compounds lacking authentic standards or surrogates’

For the quantitative analysis of ‘compounds lacking authentic standards or surrogates’ (CLASS) in environmental media, we previously introduced an effective carbon number (ECN) approach to develop an empirical equation for the prediction of their response factor (RF). In this research, a series of laboratory experiments were carried out to benchmark the reliability of an ECN approach for sorbent tube/thermal desorption/gas chromatography (GC)/mass spectrometry (MS) applications. First, the ECN values were determined using external calibration data from 25 reference volatile organic compounds (VOCs) using two MS dectectors (quadrupole (Q) and time-of-flight (TOF)). Then, a certified standard mixture of 54 VOCs was analyzed by each system as a simulated unknown sample. The analytical bias, assessed in terms of percentage difference (PD) between the certified and ECN-predicted mass values, averaged 19.2 ± 16.1% (TOF-MS) and 28.2 ± 27.6% (Q-MS). The bias using a more simplified carbon number (CN)-based prediction increased considerably, yielding 53.4 ± 53.3% (TOF-MS) and 61.7 ± 81.3% (Q-MS). However, the bias obtained using the ECN-based prediction decreased significantly to yield average PD values of 9.84 ± 7.28% (TOF-MS) and 16.8 ± 8.35% (Q-MS), if the comparison was limited to 26 (out of 54) VOCs with CN ≥ 4 (i.e., 25 aromatics and hexachlorobutadiene).     

阻尼对空爆荷载等效静载动力系数的影响

为考查阻尼参数对空爆荷载等效静载动力系数的影响,理论推导了空爆荷载下结构等效单自由体系弹塑性位移解及延性比解,设计并计算了阻尼比0.000 1～0.1、延性比1～4的20种典型工况的动力系数,并与现行抗爆设计规范动力系数公式结果进行了对比。结果表明:阻尼比小于0.000 1时可基本代表无阻尼状态,阻尼比0.01的动力系数比无阻尼的最大降低幅度为2.08%,数值差异很小,因此阻尼比为0.01以内时,可忽略阻尼对动力系数的影响;阻尼比0.05的动力系数比无阻尼的降低幅度约9.92%,数值差异较大,认为阻尼比0.05以上时将具有明显的经济效益;现行设计规范动力系数更适用于柔性结构体系,运用于刚性结构抗爆设计时,计算误差较大,对阻尼比较小的结构设计更不利。